MakerWorld
Pets
Ver Modelo
Cat Treat Toy
2.5k
Descargas
1.2k
Likes
2k
Makes
Your cat must move the sliders to uncover treats. The wells are deep enough to fit most treat sizes or a few pieces of food. Your cat can either eat the treat directly from the well or use their paw to remove it. Two slider designs are currently available - plain or ladybug. Once 3 sliders are placed on the base, simply place the top in position and gently press down to snap it in place. Print Settings Although no special settings are required, a higher infill percentage is helpful to add extra weight to the print. This will make it easier for your cat to move the sliders without the entire toy sliding around. If printing the ladybug sliders, use a color change for the last 0.4mm. The following filaments were used in the pictures above: Prusament Azure Blue PLA Polymaker PolyTerra Lava Red PLA Polymaker PolyTerra Charcoal PLA
JamesThePrinter también publica en
48 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
