Thingiverse
Catan card holder lite
von Chorris
1
Downloads
0
Likes
0
Makes
BE SURE TO SCALE CORRECTLY.
i kinda screwed the scale - 9 to 10% should be the best match :)
This remix is basically the original minus a ton of plastic. i removed a lot of the body and the "sidecut" version has also some cut out trinalges on the sides.
According to my CURA Settings the original uses 18g of Filament while this remix only uses 11g, while the printing time dropped from 2h 12m (original) to 1h 47m (this remix).
Fusion 360 files included if you want to modify it.
i kinda screwed the scale - 9 to 10% should be the best match :)
This remix is basically the original minus a ton of plastic. i removed a lot of the body and the "sidecut" version has also some cut out trinalges on the sides.
According to my CURA Settings the original uses 18g of Filament while this remix only uses 11g, while the printing time dropped from 2h 12m (original) to 1h 47m (this remix).
Fusion 360 files included if you want to modify it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
