MakerWorld
Hueforge & Lithophane
Zum Modell
CatMurai
2
Downloads
0
Likes
2
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 100x150mm in sizeYou may print at higher layer heights below the Min Depth of 0.72mmThe Max Depth is 2.7mm and the Actual Depth is 2.5mmFilaments Used: PLA PolyTerra Charcoal Black Transmission Distance: 0.3 PLA PolyLite White Transmission Distance: 5 PLA PolyLite Red Transmission Distance: 1.5This print uses 3 unique filamentsSwap Instructions: Start with Black At layer #11 (0.96mm) swap to White At layer #24 (2mm) swap to Red for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
