Thingiverse
Ceiling rose for light
por JaresB
0
Descargas
0
Likes
0
Makes
I built this rose to hide the cable and the hook of my bedroom light
It is made in two parts, rose and clamp.
The original rose is quite big, 10 cm diameter and 9 cm tall, as I had a lot of cable to hide and I didn't want to cut it out. I also made two alternative ones, a medium one (diameter 8 cm, height 7 cm) and a small one (diameter 8 cm, height 5 cm), but I didn't print them. All the roses simply rest on the clamp, no glue is needed or any other type of fitting.
The clamp itself holds thanks to a screw that is lightly tightened against the cable. I used a brass insert M3 sized melted into the plastic to be able to screw.
Printed with PLA and using support.
It is made in two parts, rose and clamp.
The original rose is quite big, 10 cm diameter and 9 cm tall, as I had a lot of cable to hide and I didn't want to cut it out. I also made two alternative ones, a medium one (diameter 8 cm, height 7 cm) and a small one (diameter 8 cm, height 5 cm), but I didn't print them. All the roses simply rest on the clamp, no glue is needed or any other type of fitting.
The clamp itself holds thanks to a screw that is lightly tightened against the cable. I used a brass insert M3 sized melted into the plastic to be able to screw.
Printed with PLA and using support.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
