Thingiverse
Celestron AVX Bubble Level
von bowiesjustaknife
1
Downloads
2
Likes
0
Makes
Heavily inspired by other designs, especially the RedneckDesign version.
I wanted something that would stay securely attached to the mount at all times, and double-sided tape wasn't cutting it. This extends the mount around the Dec screw so it can't come off. I put some double-stick foam tape on the inside just to tighten up the tolerances and prevent rattling. Works great.
I measured an angle of 14 degrees, the other designs seem to have an angle of 14.4 degrees. I find it more likely that the manufacturer would use a round number, so that's what I'm going with.
Anyhow, should be close enough.
I wanted something that would stay securely attached to the mount at all times, and double-sided tape wasn't cutting it. This extends the mount around the Dec screw so it can't come off. I put some double-stick foam tape on the inside just to tighten up the tolerances and prevent rattling. Works great.
I measured an angle of 14 degrees, the other designs seem to have an angle of 14.4 degrees. I find it more likely that the manufacturer would use a round number, so that's what I'm going with.
Anyhow, should be close enough.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
