Cell phone stand

Needed a good stand for my phone w/case, that I can charge while using, so I ended up creating this thing. It is very sturdy, and holds the phone at approx 15 degrees.

My phone is a Lumia 640, but i believe it will work for just about any phone that is narrower than 80mm.

The hole for the charging wire should fit any cord less than 13mm wide and 7mm "tall", which should be just about anything.

EDIT: Uploaded mk3, which uses a lot less plastic. Prints in 25%

Designed in Fusion 360,
Sliced in Repetier Host with CuraEngine
Printed in blue PLA from 3DNet.no

I do not recommend printing it on the side. I printed it standing the right way up, and it worked just fine.