Celtic Skull With Deeper Hole

Remixed from original to make the candle sit in much lower, will hold a candle with 68mm diameter

Did it because i printed the skull with clear PLA and i wanted the light to shine through, in the previous model the candle just seem to sit on top

Wanted to make the hollow part even deeper but that would make the skull eye's to get penetrated and leave a hole, thus you see a little small ridge behind the skull eyes.

How i printed it in ~2.5hours
I printed it with clear PLA on 0.8nozzle with 0.32 layer height, gyroid infill on 5% with 1 wall, printed out pretty cool BUT apparently the wall at the eyes was too thin on my settings so i got some holes in the wall.