Center Finder

This center finder tool is for marking the center line maximum 105 mm of width.

This is a 3 part tool.
1. The center marker
2. The straight guide
3. Stop block

**Assembly_**
Insert the cylinders shaped portion of straight guides to the holes of two side of the center maker and then glue the stop blocks with the cylinder shaped parts.
**Remember that, do not glue the center marker accidently. This must be movable.**

**Specialty_**
This tool is especially designed for marking the center line without being interrupt at the end. While the traditional tools cannot mark the straight line till the end line as they're only been guided with two dowels at each side. But this tool has a longer edge guide, so they will make sure the straight line from starting to the end.

50% infill is enough for all the parts.