Cereal Box Skadis Holder

I got tired of seeing several Skadis Cereal Box holders that did not seem sturdy enough so I created one. I previously had the skadis spool holders that were not enclosed and as you can see from the picture the humidity was about 45%. With the cereal boxes I have about 10% humidity in each one. On a standard large Skadis Board (30" by 22") you can fit 12 boxes. The end caps go on a specific side so make sure you are putting them on the correct side to make it level. Print with normal support. I used Bambu Lab PLA Basic for the Model and the support base and Bambu PETG HF for the support interface. This Skadis Holder is for a 4L Cereal Box, specifically the cereal box found below: Cereal Box: https://www.amazon.com/dp/B0C1N9C3T7?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 Boost MeIf you found the design useful, please give it a Boost. Thank you! Here is my setup in the picture: Cereal Box: https://www.amazon.com/dp/B0C1N9C3T7?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 Spool Holder for in