Cetus Carrier Handle

I devised a handle that is convenient to carry.

As an additional specification, I tried to change the handling of the filament tube. I attached a filament guide, but all is unnecessary. It is better not to use the hole built into the handle.

The difficult part to assemble is the embedding of M3 nuts. It is easy to work with using M3's 20 mm long screw.

[Caution] If the stepping motor on the Z axis vibrates after replacement and can not be initialized, do as follows. Please exchange with the genuine head and check the output of screws.

[Caution] The upper M3 screw does not reach. Therefore, it is necessary to exchange it for a long screw. The length of the M3 screw is recommended to be 12 mm to 14 mm. The same design as a genuine product is possible, but it is necessary to use a long screw to increase the strength.


[ 2020.06.06 ] Unfortunately, this part cannot be used with MK3. This is because the limit switch was added. I need the MK3 I can disassemble, but I don't h