Cetus Z-Axis Stiffness Bracket (MK3 compatible)

The original model from rreps targeted the Cetus MK2 printer. I had to change the mounting holes in the bottom of the bracket to oval ones (and also extend the pockets for the nuts), so they line up on a Cetus3D MK3.

Because it took me a bit to get it right, this is the way to mount the bracket really tight:

1. Add the bearing and the screw/washer to tighten the fall protection
2. Fit the bracket with two screws onto the stepper motor
3. Loosen all 4 screws on the z-axis extrusion mount and then firmly press it down until the bracket sits flush with the bottom plate
4. Add the bottom screw(s) (I only used the spare hole next to the foot)
5. Tighten the z-axis screws again

Thanks Marco Reps for the original model!

PS: Big fan of your YouTube channel!