CF2IDE 2.5" HDD Enclosure

This is a 2.5" hard drive enclosure/cradle made for the widely available CF2IDE you can find on Amazon, eBay or [the OSVG Store](https://store.osvg.net/?product=cf2ide-44). A bit about the enclosure:

- This was created to fit inside the IBM ThinkPad 701C Hard Drive Caddy, but this will fit ANY 2.5" IDE form factor - although I haven't gotten a CF card to work on the 701.
- The screw hole locations are of an older IDE HDD - pre 1995 I believe. These also may not matter if you don't plan on screwing it in or if you're also using a laptop caddy.
- This is for the 44-pin version of the CF2IDE version ONLY
- I made this so you can easily replace the CF card without taking it out of the caddy
- There are 3 holes sized to take a M3*4 knurled nut (as shown in the pictures)

Tip: I use [Bondic UV Plastic Weld](https://www.amazon.com/stores/page/3954B8E8-4B85-45AF-8ED2-CC807DEDC0E2) on the 2 posts to fix the CF2IDE in place. Cures in seconds with the UV light and it is VERY strong.

E