Cfmoto Uforce 1000 Rear Light Brackets

Left and right brackets for rear facing lights which mount to the roll bar door brackets. There are two mounting holes for the light depending on what style of light you are going to use, so hopefully one of them will work. Mounts to the roll bar bracket with 8mm x 1.25 pitch bolts. I used 20mm long bolts which do not bottom out against the bar (but close), and would probably use 16mm long if were to buy them again. Printed upside down w/ support (only needed for in the 3 bolt holes. Might print ok w/o but haven't tried it yet), 30% infill.
I used PLA + which should be fine in the summer heat, but may reprint in ASA if they start to sag in the heat.