CFS Heater block mount

Simple mod for CFS.Add heater block to CFS. I use this 3D printer heater for this mod:https://www.aliexpress.com/item/1005007886254093.htmlThey are widely available on Amazon, eBay too. Just make sure you have this model as white seems to be slightly different and may not fit nicely. I like this model as it keep temperature settings after powering off. It heats up to 50'C. It heats enclosure up to 45'C within 20minutesand it is enough to keep filament dry. After 24h enclosure reach true 50'C and 10% humidity inside. During testing I found that internal CFS temp and humidity display is not showing correct readings! I have added my independent thermometer. Please see pictures.Speed up your prints with preheated filament. I upgrading CFS to be able to print more technical filaments like PA6CF or ~ASA, ABS.You can drill to holes in top cover for mounting heater case. It will void your warranty or use double sided tape. Due to heat, tape may fail with time. The other hole is for power cable. I drilled 14mm hole and use adapter to seal it.Enclosure is thick enough for taping if you do not want to use nuts. I use M5x8mm countersunk bolts with locking nuts.Plug installation is in three steps. Power cable first, then place one half in place. Center cable in the middle and press the other half. It should snap together. It has a bit of play so cable can be pull through. EnjoyUpdate: Anything printed inside needs to be done with heat resistant material like ABS, ASA or similar. PLA is not good when you want to keep temperature set to 50'C as it will deform with time. I have printed new top bumpers with ABS-CF and they works perfect!Works well and it could not be simpler!