CG Stand Addon

This is an addon for thing:3113191
https://www.thingiverse.com/thing:3113191

I printed everything at 30% infill except for the bolts, Those I did at 80%.
I think 80% infill is stronger than 100%. (I could be wrong)

All pieces have been uploaded, I will be adding more instructions over the next few days.

Qty 2 -- 625zz 5 x 16 x 5 mm bearings will be needed for the pivot.

https://www.amazon.com/gp/product/B07DZDZNJM/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

To assemble, remove the support arms from the stand assembly arm (thing:3113191).
Bring them both straight up vertical.
Attach the new CG Bracket between the two support arms using the same bolt, nut and knob that was holding the support arms originally.
Attach the new CG Arm to the bracket using a new 1/4” x 1 1/4” Carriage Bolt and Nut along with the newly printed Knob.
Insert the bearing into the CG Rocker with the bearing flush with the side without the line.
Lightly sand the bolt shoulder before trying to