MakerWorld
Sport & Outdoors
Go to Model
Chain and Rope Handle
22
Downloads
11
Likes
14
Makes
This model is my first ever posted so it is a little rough. It is used as a handle for paracord, by simply looping the rope through the hole. To use as a chain handle you must pause the print at 34 minutes, and place the chain ring in the groove before unpausing the print. The ring needed is 4mm width, with a inside diameter of 12mm. The original intent is to be used as an ergonomic grip fora small and medium game drag. However it can be used for what ever you pleaseBoost MeThis is my first model posted and a boosted would mean a lot! Thanks you very much!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
