Thingiverse
Chain Bracelet dual/single extruder
door pulcepulce
11
Downloads
10
Likes
0
Makes
Piccola modifica al fantastico lavoro di lukeskymuh.
é stata aggiunta la possibilità di chiudere il braccialetto con un perno e suddiviso per poter essere stampato in due colori con sistema a doppio estrusore.
Per la chiusura basta un perno 3x30mm oppure anche una vite m3x30
I supporti sono necessari solo sui pezzi dove ci sono le chiusure.
é presente anche il file Fusion se volete divertirvi anche voi a personalizzare
Small change to lukeskymuh's fantastic work.
the possibility of closing the bracelet with a pin and subdividing it to be able to be printed in two colors with a double extruder system was added.
For the closure just a 3x30mm pin or even a m3x30 screw
The supports are only needed on the parts where there are closures.
é stata aggiunta la possibilità di chiudere il braccialetto con un perno e suddiviso per poter essere stampato in due colori con sistema a doppio estrusore.
Per la chiusura basta un perno 3x30mm oppure anche una vite m3x30
I supporti sono necessari solo sui pezzi dove ci sono le chiusure.
é presente anche il file Fusion se volete divertirvi anche voi a personalizzare
Small change to lukeskymuh's fantastic work.
the possibility of closing the bracelet with a pin and subdividing it to be able to be printed in two colors with a double extruder system was added.
For the closure just a 3x30mm pin or even a m3x30 screw
The supports are only needed on the parts where there are closures.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!