Chain_Chomp_Switch_Cartridge_Stand

This is a stand for my previous "Chain Chomp Switch Cartridge Holder" design.

|Materials Needed|
1) super glue
2) acrylic paint (if wanted to paint)
3) sand paper (for smoothing of support material, if needed)

|Printing Instructions|
1) Print the "Base_CC_Stand" file at 10% infill density (print speed was a 50 mm/sec).

2) Print the "Base_Link_CC_Stand" at 25% infill density (print speed was a 25 mm/sec)..
3) Print the "Post_CC_Stand" at 25% infill density (print speed was a 40 mm/sec)..
4) Print 12 of the "Link_Halve_CC_Stand"'s at 25% infill density (print speed was a 25 mm/sec).

|Assembly|
1) Do all PAINTING and SANDING and make sure the post fits in the pilot hole of the base.
--> Base: Green
--> Chain Links: Silver
--> Post: Brown

2) Super glue the Chain Link Halves, one by one, starting at the chain link connected to the Post. Should have 6 interlocking chain links connected to the post.
3) Slip the end of the chain on to the "Base_Link" and t