Thingiverse
Chainsaw Cap Above Chain
di TJ_OVERKILL
0
Download
0
Likes
0
Makes
I lost the rubber cap that was above the chain on the chainsaw.
32mm ID
38mm OD
I printed in PETG so you have to take the side off to put it in and tighten it back up. But I had to change the chain as well so it worked out.
Ideally would be better if printed in TPU. But it works either way.
32mm ID
38mm OD
I printed in PETG so you have to take the side off to put it in and tighten it back up. But I had to change the chain as well so it worked out.
Ideally would be better if printed in TPU. But it works either way.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
