Chamber Heater - Externally Mounted

A clean, polished-looking modification to print ABS, ASA, and Nylon filaments without any warping. PPA-CF & PAHT-CF print with greatly improved layer adhesion. Requires no internal wiring inside printer, while adding minimal bulk. Housing hanging off the side of the printer will measure 8.4 cm W x 6.5cm H x 8.7 cm or 3.4in W x 6.3 in H x 3.4 in D. Can be installed on any brand or model of enclosed printer with enough surface area on a side panel to allow the enclosure to be mounted after drilling large (50mm / 2 inch) holes in the printer's side panel. Was designed for the P1S and X1C. Will hold any temperature you set it to via the wired remote, which is seen in the photos secured over the door with double-stick tape. Displays current temperature at the air intake, can be set on a timer or to run continuously. Maximum temp is 70C. Profiles are included for ABS, PA6-CF, and PAHT-CF / PPA-CF, which all have the heat resistance needed to house this chamber heater. PETG and PLA will m