Thingiverse
Chameleon HD Conversion
por rdennisak
5
Descargas
4
Likes
0
Makes
This is for replacing the GoPro tray on your Chameleon to use just a Runcam Split, or Foxeer MIX for fpv and HD video.
It has mounting holes for attaching the control board below the camera.
A separate lower bumper is optional, but it protects the board from debris and moisture.
Also has an antenna mount for the Crossfire Imortal T antenna.
NOTE: you need to use 3 x 20mm standoffs to mount the seat, and the lower bumper.
YOU MUST drill out the threads in the aluminum sides. Don't need threads there, even without this conversion - not sure why they are threaded to begin with. Use a 1/8" bit and that will get rid of the threads.
It has mounting holes for attaching the control board below the camera.
A separate lower bumper is optional, but it protects the board from debris and moisture.
Also has an antenna mount for the Crossfire Imortal T antenna.
NOTE: you need to use 3 x 20mm standoffs to mount the seat, and the lower bumper.
YOU MUST drill out the threads in the aluminum sides. Don't need threads there, even without this conversion - not sure why they are threaded to begin with. Use a 1/8" bit and that will get rid of the threads.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
