Charge Cable Holder Wall Clip

I don't have space next to my bed for a nightstand and was tired of fishing for the cable off the floor after turning in for the night.

Best printed on its "side" so that if you are looking at it from above it almost looks like an alligator with an open mouth. I have had success printing like this without supports and 35% infill feels strong enough based off my use. I think it would pull off the wall before the print broke. It has some flex to allow the charge cable to be removed. I also filleted the edges to hopefully prevent frays to the charge cable.

This is sized for a command strip to fit in the back and the tab be accessible from the bottom.

The interior where cable rests is 5mm. The whole print is only slightly larger than the command strip.

Pretty simple print so no real post print processing it printed as noted above.

Thanks and happy printing!