Charizard Pokemon 3D Flat Print

This is a flat layered 3D-printed Charizard wall or desk decoration. It works best as desk decor, shelf display, kids room decoration, or a collectible display piece. Lightweight and colorful, it’s ideal for adding a fun accent to a gaming setup, office desk, or bedroom shelf. The great part about these models is they only take a couple hours and use less than 100g of total filament. Each layer is its own color so there are only seven color changes. When changing the colors if you do not have an AMS you can pause the print when each color is finished and change the color. The base is 4.08mm thick and roughly 9" in height. -Initial layer height is .24 and layer heights are .08.-I use a height range modifier from .24-4.08 at .24 with 15% infill, 3 bottom shell layers and 5 top shell layers. -After 4.08 print it at .08 layer heights. For more Pokemon and other gaming prints check out my profile. You do not have to use the exact colors below but it will look better if you do. Swap Inst