Chastity Dummy Lock Revised

Date March 24 2022 Thingiverse User aifwo Added A Revised Version to the Dummy Magic Locker that's easier to withdraw because it has a hex shaped base. Prints without supports in upright position. A little glue stick will help hold it in place and a slow printing speed will help and using a low temperature and fan on past the first two layers will also help. Make sure you print it at 100% infill for strength and don't twist it or it will break. The original Dummy Lock has also been repaired as the original had a flaw. The original file is still available in the file too. Don't insert the original one or the revised one into a device unless that device has a hole in the opposite side which you can use to push the dummy lock out by way of a pen tip or something. Original File was https://www.thingiverse.com/thing:2692974
Dummy 'Magic Locker' by deprav3d is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/