Thingiverse
Checkered Flag Coin Display
by dirdled
0
Downloads
0
Likes
0
Makes
Hey everyone,
I’ve got another print that I feel is worthy of sharing! I’m really happy with how it turned out, but it’s a bit of a challenge to print (or maybe I’m just not quite there yet). I used my Ankermake printer with the settings I mentioned. I started with black and changed the filament at the following layers:
1-30: Black
31-35: White
36-91: Black
91-96: White
96-128: Black
You might be able to skip a couple of those stops if you leave the middle section white, but I liked the way the edge looks with the two clean white stripes, so I changed it back.
I’ve got another print that I feel is worthy of sharing! I’m really happy with how it turned out, but it’s a bit of a challenge to print (or maybe I’m just not quite there yet). I used my Ankermake printer with the settings I mentioned. I started with black and changed the filament at the following layers:
1-30: Black
31-35: White
36-91: Black
91-96: White
96-128: Black
You might be able to skip a couple of those stops if you leave the middle section white, but I liked the way the edge looks with the two clean white stripes, so I changed it back.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
