MakerWorld
Hueforge & Lithophane
Go to Model
Cherry Blossoms
55
Downloads
46
Likes
32
Makes
Feel free to adjust the size as needed, just do not adjust the thickness (Z) in your slicer! You can adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 108x162mm in sizeYou may print at higher layer heights below the Min Depth of 0.24mmThe Max Depth is 2mm and the Actual Depth is 2mm Filaments Used:Peakace Black PLAElegoo Red PLAPolylite Pink PLASunlu White PLAThis print uses 4 unique filamentsSwap Instructions: Start with Black At layer #11 (0.96mm) swap to Red At layer #14 (1.2mm) swap to Pink At layer #16 (1.36mm) swap to White for the rest. ATTENTION: the result may vary slightly depending on the brand and transparency of the filament used. Boost MeHelp me get bigger printer to print out bigger projects!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
