Cheshire Cat

Cheshire Cat from Alice and Wonderland I had a lot of purple ABS left over from my last project (Dino Flintstone) and decided on building the Cheshire Cat. Since my daughter loves Alice in Wonderland, this was an easy choice to make. The model as printed is 25cm high and 28cm long, however since it is sliced into pieces to allow for the colors, you only need to check the size of the largest flat piece (body_6.stl, approx 130mm x 125mm) to determine your print size. The tallest piece is head.stl, 63mm. The model should scale well except for the eyes (just the black dots) and whiskers. I used glow in the dark ABS for the mouth for that extra special touch. Gcode files for the MK3 were supplied by maker "DORFFMEISTER", thank you! Enjoy! Print instructions Rafts: No Supports: No Resolution: .2mm Infill: 10% Notes:** See important notes in the 'extra notes for printing' section for the black eyes and whisker pieces. I printed all the parts except for the head with one shell. I printed the head with two shells due to the 'extreme' overhangs (60 degrees max) which I am always cautious with. Building the model Colors pink: face ear_r ear_l arml_1 arml_3 arml_5 arml_7 armr_1 armr_3 armr_5 armr_7 arm_bump (two copies) tail_2 tail_4 tail_6 tail_8 body_1 body_3 body_5 body_7 body_9 body_11 body_13 body_bump (four copies) purple: head arml_2 arml_4 arml_6 armr_2 armr_4 armr_6 tail_1 tail_3 tail_5 tail_7 tail_9 body_2 body_4 body_6 body_8 body_10 body_12 body_14 white (or glow in the dark): teeth_1 teeth_2 teeth_3 black: eyebrow_r eyebrow_l eye_r eye_l whisker_l (three copies) whisker_r (three copies) yellow: eyeball_r eyeball_l Extra notes for printing Rafts are not required, except for the eye_r and eye_l parts due to the small sizes. Be sure to thoroughly clean any first layer 'squish'. Depending on your first layer squish, you may need to resize the bumps to reduce their height. Without a first layer squish all pieces fit perfectly. Due to the narrow size of the whiskers, I p