Chess Piece (rook)

This is a simple rook chess piece that I designed on Fusion360. Be sure to read through the part about print settings, so it will work the best for you! When I printed this build, I used transparent white PETG filament, though any filament would work (PETG, PLA, etc.) When printing it, here's some tips:

-Set heating bed temperature to 70 degrees Celsius

-Set flow rate to 105% (this makes the print smoother)

-Make sure the filament gets hot enough

-When creating supports for the rook, make sure its not one solid support piece looping around the whole thing, because if you do it, then it gets extremely hard to take off (tree supports are recommended)

I hope it works for you to print! Thanks! 🙂