Chichen Itza pyramid Candle Mold

Candle mold of the Chichen Itza Pyramid (cast from the model done by ChapinEagle02: https://www.thingiverse.com/thing:675795)
Print the two halves with the base of the pyramid on top, 0.2 mm resolution, 20% infill.
Pass the wick through the small hole at the bottom, keep the two halves tightly close with two small clamps and coat the inner part with a thin layer of olive or seed oil for easing the detaching of the candle.
PLA is fine but pour the vax at a temperature of about 50 degrees. Extract carefully the candle after 2 or 3 hours, trim the wick in excess.
I have printed my model at 50% scale.