Thingiverse
Chimera-Cyclops E3d Carriage
by spoos
79
Downloads
49
Likes
0
Makes
This is a carriage for E3d's Chimera/Cyclops ,i designed but not tested yet. Made for Vulcanus Max CoreXY 3d printer but it may be suitable for other printers too. The distance of the lm10uu's is 50mm center to center.
I plan to buy the famous E3d's dual extruder solution and then print this assembly.
I use an Inductive Proximity Sensor LJ18A3-8-ZBX so i wanted it to be compact, modular and very rigit at the same time. The sensor screws in the bottom part.
For the assembly it needs 4 zipties, 5xM3 screws at the top, and 2xM3 screws at the back of the Heatblock. Each belt of the CoreXY cinematics, can be tighten individually.
Solidworks and Stl files are available.
If you have any recommendations, leave a comment so we can improve it.
Last Update: 13/9/2016 12:42
I plan to buy the famous E3d's dual extruder solution and then print this assembly.
I use an Inductive Proximity Sensor LJ18A3-8-ZBX so i wanted it to be compact, modular and very rigit at the same time. The sensor screws in the bottom part.
For the assembly it needs 4 zipties, 5xM3 screws at the top, and 2xM3 screws at the back of the Heatblock. Each belt of the CoreXY cinematics, can be tighten individually.
Solidworks and Stl files are available.
If you have any recommendations, leave a comment so we can improve it.
Last Update: 13/9/2016 12:42
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
