Thingiverse
Chiron Filament Guide Updated
39
Downloads
14
Likes
0
Makes
A filament guide utilizing a piece of bowden tube and a spare coupler (6mm or 10mm thread) to guide the filament in nicely from any angle! No more chewing through the runout sensor, just replacing a small piece of bowden tube every now and then.
2021-02-16 UPDATE: I've updated the part so it is reinforced to the screw that holds the filament sensor, note that you will need a longer screw and a nut to attach this. It makes it way more rigid and secure.
I've also re-worked the thread so that it is way easier to thread in the couplers even when printed as the STL lays the part down.
It is fastened to the runout sensor using the two holes already in it using:
2x M3x20
2x M3 nuts
2021-02-16 UPDATE: I've updated the part so it is reinforced to the screw that holds the filament sensor, note that you will need a longer screw and a nut to attach this. It makes it way more rigid and secure.
I've also re-worked the thread so that it is way easier to thread in the couplers even when printed as the STL lays the part down.
It is fastened to the runout sensor using the two holes already in it using:
2x M3x20
2x M3 nuts
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
