Chiron - Z Bracket Remix

Currently working on designs for Rail Mounted ED3 Hemera and wanted the spread the top to clear both sides 100%, I redid the mounts for front and rear as the angles changed also made them a bit thicker.. I printed with 0.6 Nozzle, @ 0.275Layer, 50mm/sec, 8 top and bottom and 8 outlines, I did 90% infill, guess could of done less.. but why not, and in ABS. These are a little thicker and wider than original version.. and while holes were entered at 10mm I am using the more readily accessible 3/8" rod, which is about 9.5mm so close enough.. I'll add more pics once its together.. right now only one side and one Rod is bolted into place.. already feels much more solid.