ChopSticks V2.2

Things I didn't like on the original chopsticks frame:
1. It was hard to make and too complicated.
2. Broke to easily and warped after some time.
3. 2mm carbon fiber rods suck!

Things I improved on:
1. Easier to make!!!
2. Easy to replace broken parts
3. TPU arm ends to prevent nasty crashes, adds to motor protection, and adds to motor dampening.
4. A brace to distribute force when crashing.
5. No glue required!!

There are 3 main versions namely:
- 26x26 board 65mm props
- 26x26 board with 3" props
- Tinyhawk board with 65mm props

there is also a choice for 4 hole or 3 hole motor mounting. You're welcome. HOWEVER, the 3 hole arm ends are not that good and I haven't measured them out if they have the same lengths. Use them with caution! they're also not that nice and I highly recommend the standard 4 hole motors!!!

Things you will need:
- 3mm Carbon fiber rods
- An object to cut the rods (ex. saw)
- A 3D printer or someone who owns one
- TPU and PLA plastic