Thingiverse

Choyong WT2 Stand

by W8LN

0 Downloads

1 Likes

0 Makes

This is a stand for the Choyong WT2 Shortwave/FM/MW/UHF/Internet Radio. It's a remix of the holder for a belt clip.

On thing that make a stand useful is that it holds the radio in place while charging. The USB port it poorly designed and the least bit of motion will cause the cable to pop out.

I printed this with ABS because I needed to print something else with ABS at the same time, but it should do fine with PLA.

I experimented with various orientations in my slicer (upright, upside down, face down, face up, sideways) to see which was most economical because of the supports. Upright used the least filament (and was quickest).

This radio can be used on the 70 cm. amateur radio band in addition to all of its receive functions.

amateur radio choyong Ham Radio hamradio handheld Handheld portal device handheld radio internet radio internet radio case radio radioamateur shortwave shortwave radio shortwave radio stand ShortwaveListening web internet radio wt2

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format