Christian Cross

Printed on a 330x330mm bed size so adjust in your slicer for your bed size.

I would suggest you make three sections of this with the first section .1mm layer height, the middle section .2-.28, and the final section back to .1mm. What this does is allow the top side to have a better bridge of four layers. The top and bottom (will become the front and back) are 0.4mm thick so you can see through it using clear filament.

.3mf has been uploaded for Prusa slicer to show the ranges I mentioned.

Angels Tree Topper can be found at https://www.thingiverse.com/thing:4052813