MakerWorld
Hueforge & Lithophane
Zum Modell
Christmas hat letters
6
Downloads
6
Likes
2
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 150x150mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mm Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA Kingroon Red Transmission Distance: 4.2 PLA BambuLab Basic Mistletoe Green Transmission Distance: 1 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filaments Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Red At layer #16 (1.36mm) swap to Mistletoe Green At layer #24 (2mm) swap to Jade White for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
