Thingiverse
Christmas Light Storage
by viperchaos
13
Downloads
43
Likes
0
Makes
Ho-Ho-Ho folks,
My parents purchased a large version of these and tasked me with shrinking them down for smaller sets of lights.
Nothing fancy here just PLA...
The model sits at 200mm x 121mm x 7mm so should fit on most printers.
I would not attempt to scale this up unless you truly don't mind the designated centralized wire clips to be oversized!
Other than that here's the settings i used:
Printer: AnyCubic Kobra 2
Slicer: Cura
Resolution: 0.3mm ( 0.2mm would be better )
Infill: 20%
Supports: None
Time to print: 2hrs 10mins
Material usage: 14.4m
Have a great christmas :)
My parents purchased a large version of these and tasked me with shrinking them down for smaller sets of lights.
Nothing fancy here just PLA...
The model sits at 200mm x 121mm x 7mm so should fit on most printers.
I would not attempt to scale this up unless you truly don't mind the designated centralized wire clips to be oversized!
Other than that here's the settings i used:
Printer: AnyCubic Kobra 2
Slicer: Cura
Resolution: 0.3mm ( 0.2mm would be better )
Infill: 20%
Supports: None
Time to print: 2hrs 10mins
Material usage: 14.4m
Have a great christmas :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
