MakerWorld
2D Art
Go to Model
Christmas Snow Globe
52
Downloads
37
Likes
30
Makes
Christmas Snow Globe Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 100x126.66mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.7mm and the Actual Depth is 2.8mm Can be rescaled just remember not to change the Z axis. Filaments Used: PLA+ Sunlu Black Transmission Distance: 0.6 PLA+ Sunlu Grey Transmission Distance: 2 PLA+ Sunlu White Transmission Distance: 5 Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Grey At layer #21 (1.76mm) swap to White for the rest. After printing use a lighter/ torch, by quickly passing the printed parts you will get rid of the tiny stringing on these type of prints. Thanks
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
