Christmas Star

The design is simple using only 3 basic parts: a 20 sided icosahedron Frame, 19 Spikes, and 1 Base (to mount it on a tree).

The Star is approximately 17.6 cm in diameter. The parts of this design can be scaled to any size, using your slicer's scaling options.

I used this Acrylic Cement (https://www.tapplastics.com/product/repair_products/plastic_adhesives/tap_acrylic_cement/130) and this Small BD-25/2 Hypo Applicator (https://www.tapplastics.com/product/repair_products/plastic_adhesives/hypo_type_solvent_cement_applicator/409) to glue everything together.

For the lights I used these Govee fairy lights.
https://www.amazon.com/Govee-Operated-Waterproof-Silver-Plated-Festivals/dp/B07R8V53S4
It took about three 1 meter strands (20 LEDs/strand).

To assemble it, I picked one side of the Frame and ran lights into the center, then using tweezers I pulled about 3 LEDs out each hole in the Frame. Bending the wires so there was one LED at the tip, one in the center, and another towa