Christmas Tree Addressable LED

People saw this on Reddit and wanted the files so here they are.

All of this was printed on my Prusa mk3 with 0.3 layer height.

Cover - zero infill and fuzzy skin on

LED Holder - Printed with 4 perimeters and zero infill

LED Tray -15% infill with 4 perimeters

Trunk - 4 perimeters and 15% infill

Stand - I painted on some supports where I felt they needed it. 15% infill and 3 perimeters

USB-C Holder - Printed on 0.2mm

ESP32 Holder - 3 perimeters with 15% infill

I used this USB-C PD at 5v https://www.amazon.com.au/dp/B0DFC1LR6Z?ref=ppx_yo2ov_dt_b_fed_asin_title
The ESP is a 30 pin Dev board
LEDS were WS2812B 96 per meter DC5V

I set WLED to be power limited so I can get under 3A of current to use USB-C PD with a good wall plug for 5V 3A