Slicer Discord
Christmas Tree Long Funnel – Modelo 3D imprimible de Thingiverse Thingiverse

Christmas Tree Long Funnel

por SteevyT
11 Descargas
12 Likes
0 Makes
Ver Modelo
This is a funnel end that is intended to fit over 3/4" SharkBite brand PEX to make an inexpensive Christmas tree watering funnel. There are small channels in the end that allow air to escape preventing a column of air from forming in the pipe and preventing water flow down. No glue was needed to attach it to the pipe successfully.

A 5-foot section of PEX can be purchased at Lowes for about $2.50 at the time I'm writing this (12/22/2018) and filament+electricity cost was approximately $3.50.
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Pegado
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

SteevyT también publica en

16 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

1 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección