MakerWorld
Decor
Go to Model
Christmas Tree
18
Downloads
8
Likes
5
Makes
Christmas tree with a light compartment in the base. As you can see from the photos, I carved the light control housing into the base so it's a single piece, allowing us to position it wherever we want without any issues. On the back, I drilled a hole where I can use a pin to remove the control when changing the batteries.The star is very small, so be careful when removing the supports, as you might break the pins.If you're printing the tree with the H2 series, you'll need to disable the spaghetti detection and nozzle clog detection features. Otherwise, printing may stop at some point and require your intervention, so I recommend disabling them.
Gettone also publishes on
111 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
