Thingiverse
Christmas tree star
von ftr123_2
24
Downloads
5
Likes
0
Makes
Made a star for my grandparents christmas tree.
I printed it in two halves, golden filament, rotated by 90°at y-axis, glued them together with epoxy, any other glue might work just fine ;)
Hole at the bottom is 15mm in diameter, should fit most trees, if it doesnt --> knife or scissors.
Happy printing! ;)
Made in Fusion360 and Meshmixer
I printed it in two halves, golden filament, rotated by 90°at y-axis, glued them together with epoxy, any other glue might work just fine ;)
Hole at the bottom is 15mm in diameter, should fit most trees, if it doesnt --> knife or scissors.
Happy printing! ;)
Made in Fusion360 and Meshmixer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
