Thingiverse
Chromecast Remote Holder
door Donkieyo
196
Downloads
206
Likes
6
Makes
###Holder for the Chromecast with Google TV remote.
You insert the remote by sliding it in from the top. The bottom section flares out abit to prevent it from passing straight through. This allows the fit to be quite loose which makes it easy to remove/insert it.
Comes in 3 different files, depending on how many screw holes you want. I am currently just using double-sided 3M tape and it seems to be sturdy enough, but your milage may vary.
Print with the flat top side down to minimize supports and maximize the strength of holder.
Might need a light sanding on the inside if the fit is too snug.
You insert the remote by sliding it in from the top. The bottom section flares out abit to prevent it from passing straight through. This allows the fit to be quite loose which makes it easy to remove/insert it.
Comes in 3 different files, depending on how many screw holes you want. I am currently just using double-sided 3M tape and it seems to be sturdy enough, but your milage may vary.
Print with the flat top side down to minimize supports and maximize the strength of holder.
Might need a light sanding on the inside if the fit is too snug.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
