MakerWorld
Other Miniatures
Go to Model
Chubby Chibis - Toad
43
Downloads
71
Likes
22
Makes
This is part of a series of chubby little stout friends that sit happily on your desk! See the bottom of the post for other Chubby Chibis you can collect! Each plate should fit an A1-Mini! As seen above, I've included the following plates: 4 x Full Color1 x Full Color4 x Single Color1 x Single Color All models have flush to infill enabled to help reduce waste. Walls are set to 3 to help shield the viewer from any colors that might be seen on the inside. It is 98% effective. Should you desire perfection, either raise the wall count to 4, or, disable flush to infill. This will increase filament usage and the cost of perfection. He's busy talking to all his chibi friends! My flushing multiplier ratio is at 1.00x. I didn't see any bleed from color to color, though I suppose artifacting is possible if strings are floating around the chamber or something. <img src="https://makerworld.bblmw.co
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
