Thingiverse
Chuck and Nerd Herd Logos
door ddemtl
5
Downloads
10
Likes
0
Makes
These are logos for the Chuck TV series, made to allow filament change.
For filament change, set your Layers to 20 for the Chuck Logo.stl file and 6 for the NerdHerd_logo.stl file.
The Chuck Logo.stl file doesn't require a brim and infill can be as low as 10% without a problem.
The NerdHerd_base.stl file doesn't require a brim and infll can be as low as 10% without a problem.
The NerdHerd_logo.stl file is VERY sensitive to bed adhesion and is best done with a brim. Infill should also be 100% for this file, so that the colors are as opaque as possible.
After the NerdHerd parts are printed, the logo will need to be glued in the middle of the base.
For filament change, set your Layers to 20 for the Chuck Logo.stl file and 6 for the NerdHerd_logo.stl file.
The Chuck Logo.stl file doesn't require a brim and infill can be as low as 10% without a problem.
The NerdHerd_base.stl file doesn't require a brim and infll can be as low as 10% without a problem.
The NerdHerd_logo.stl file is VERY sensitive to bed adhesion and is best done with a brim. Infill should also be 100% for this file, so that the colors are as opaque as possible.
After the NerdHerd parts are printed, the logo will need to be glued in the middle of the base.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!