Chum Tube

This model came about because of the clean out adapter and the bottom cap. I had ordered 4" parts and a 2ft section of 4" pipe. Only to find out that the 4" pipe section that was given to me was actually 5.5" OD and the other items wouldn't fit. Well to add insult to injury Home Depot would take the pipe back but wouldn't take the other parts back, and the only other option would be to buy a 20ft piece of pipe at 50$, that was a no go for me. So I came home, took ID measurements of the fittings and created this tube in blender with premade holes in the sides. You will find 2 different STLs, one is 6" long x 4" and the other is 8" x 4". The photo is of the 8"Note: The reason you see light is because I stuck a headlamp in the tube itself to show the holes. There are 4 sets of 10 holes going around the tube. However 2.5 on each end will be closed by the fittings. I printed this using SUNLU Black PETG with the following belowLayer Height: 0.20mmI