Thingiverse
Church Chair Riser
von HughJayness
1
Downloads
0
Likes
0
Makes
My table was a little bit high for my chairs. These risers will lift the chair about 2 inches.
I printed in the vertical orientation with support. (It requires very little support) I printed mine with PETG but PLA would work at a higher infill %.
These work great, and are very durable.
I printed in the vertical orientation with support. (It requires very little support) I printed mine with PETG but PLA would work at a higher infill %.
These work great, and are very durable.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
