Slicer Discord
Cigarette Pen – 3D-Druckmodell von MakerWorld MakerWorld
Office

Cigarette Pen

4 Downloads
7 Likes
0 Makes
Zum Modell
first of all i want to say I don’t smoke. Smoking smells absolutely gross and I’m stoked younger folks aren’t puffing away like past generations. If you dont smoke now PLEASE! dont start.. never even try it, its not worth it. Solid advice i got from a pretty crappy person is “You can never miss something youve never tried” seriously if you dont smoke.. dont start its gross. Anyway… here’s the realistic cigarette pen! you will need to take the pen tip and ink part out of a bic pen and cut the ink tube to under 95mm. check the photo to see where i measured from and what part of the pen you need! it can take a bit of wiggling to fit in but i promise you it does and its removeable if you ever run out of ink. Fuzzy Skin SettingsTo get that cigarette-paper texture, I played with Fuzzy Skin in my slicer. You can probably tweak these better than I did, but the settings in the file are where i ended up. If you want to mess with the settings here a Grok explanation on what the settings do and wh
Kategorie
Office
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

PrinterInUse veröffentlicht auch auf

96 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen