CineVectron mounting bracket v2.0

CineVectron mounting bracket v2.0
Designed by Darryl Hirschler

This is a mounting bracket for the CineVectron board set, so that the CineVectron board and FPGA can be installed easily into an Asteroids or Asteroids Deluxe arcade cabinet. It is designed to slide into the stock PCB guide rails for the gameboard and line up the edge connector where it is expected to be.

Features:
- It is the same height as an Atari Asteroids or Asteroids Deluxe gameboard so that it slides into the PCB guide rails in the cabinet. And it has holes for securing it in place with screws.

- With the CineVectron board mounted, the edge connector is at the same height as an Atari Asteroids or Asteroids Deluxe gameboard so the wire harness will plug right in without stretching or giving too much slack.

- The CineVectron edge connector is recessed so it is not as vulnerable to accidental damage due to sticking out too far.

- IT is designed as several pieces so that it can be printed on a small 3D